Hisense Appliance Repair Services

Hisense appliances (especially refrigerators, A/C units, washers, and TVs) use budget-oriented electronics and compact designs, which often lead to:

• Refrigerators not cooling properly – inverter compressor failure, low refrigerant, or thermistor drift
• Units flashing error code “E1”, “E2”, or “E6” – sensor fault (evaporator or ambient), control board communication error, or defrost circuit failure
• Freezers over-icing or leaking – blocked defrost drain or failed heater/defrost thermostat
• Washer showing “E3” or stuck during spin – unbalanced load sensor or Hall sensor failure on BLDC motor
• Touch panel not responding or resetting – UI board capacitor failure or faulty ribbon connection
• A/C units not turning on or showing “E5” – voltage protection fault, outdoor PCB relay failure, or fan motor feedback error
• Refrigerators running continuously – temperature control board relay stuck or bad door switch
• Water inside fridge compartment – defrost overflow due to clogged drain or insulation breakdown

Diagnostics are available on most models through button combinations or flashing LED patterns, although limited in scope. Error codes (E1–E9) typically indicate sensor or power board faults. Most repairs require voltage checks across PCBs, NTC sensor resistance testing, and relay/triac board inspection. We perform component-level repair including inverter board testing, capacitor/diode replacement, and full sensor calibration.